Ergo ii with iso wings, Installation – Kuryakyn 4057 ERGO II/6 ARMS with ISO WINGS User Manual

Page 2

PAGE

YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST SYSTEM
DURING INSTALLATION. ENSURE THAT THE ENGINE

AND EXHAUST SYSTEM HAVE FULLY COOLED TO

PREVENT INJURY.

Use the supplied anti-seize for any chrome-to-chrome
fasteners; this will prevent galling and make future removal
of fasteners easier.

INSTALLING CLAMP AND SWINGARM ASSEMBLY ON THE

ENGINE

GUARD

STEP 2

Locate the left mount; the mounts are side specific (PIC 1) so be sure you

have the correct mount before attempting the installation. Visually inspect

the angle where the swingarm will be attached. The mount should be

angled slightly back, toward the rider, NOT forward.

STEP 3

Remove the four 1/4”-20 fasteners securing the mount together and

separate the upper and lower halves.

STEP 4

Insert the adjustable stop into the lower half of the mount. Thread two of

the included 3/8”-16 set screws into the bottom of the mount. PIC 2

Install the mount onto the engine guard. Loosely secure the mount with

the four 1/4”-20 fasteners. Do not tighten at this time. PIC 2 Secure the

swingarm to the cogged mount using the 1/2”-13 x 1-1/4” Button Socket

Cap Screw and wave washer making sure the cogs on the swingarm line

up with the cogs on the mount. The swingarm must be positioned level

with or above the engine guard. FIG 1

FOOTPEGS MUST BE INSTALLED SO THEY WILL FOLD
UPWARD AND REARWARD IF HIT BY ANY OBJECT.
FAILURE TO ADJUST THE FOOTPEGS TO OPERATE IN

THIS MANNER COULD RESULT IN SERIOUS INJURY OR

DEATH.

STEP 5

Insert two roll pins into the clevis positioning holes. PIC 3

STEP 6

Insert the 1/2”-13 x 1” Hex Head Cap Screw and internal tooth lock

washer through the swingarm and thread it into the clevis. Determine the

desired angle of the foot peg using the positioning holes in the swingarm.

Make sure the roll pins line up with two holes on the swingarm and

tighten the cap screw. The roll pins will be pressed into place in the

swingarm as you tighten the clevis finger tight. PIC 4

STEP 7

While pushing down lightly on the swingarm, adjust the two set screws (PIC 2) below the

adjustable stop to fine tune the foot peg angle.

STEP 8

Tighten the four fasteners on the bottom of the clamp; pushing down lightly on the swingarm

while tightening the fasteners to take up any slack between the mount and the engine.

ERGO II with ISO WINGS

INSTALLATION

-cont.-

PIC 2

SET SCREWS

ADJUSTABLE STOP

PIC 1

LEFT

RIGHT

ANGLE GOES
TOWARDS REAR

OF BIKE

PIC 3

SWINGARM

PEG MOUNT
WITH ROLL

PINS