Kuryakyn 8931 PLUG-N-GO DRIVERS BACKREST for GL 1800 - Manual (Page 3)

STEP 10
Insert the receiver into the slot cut into the foam until it contacts the seat pan. Align the threaded
holes in the receiver with the slots in the seat pan. The setscrew from STEP 3 will face to the front
of the seat. PIC 1
STEP 11
Turn the seat over. Using the included M6-1.0 X 25mm
Button Socket Cap Screws and M6 Flat Washers, attach
the support bracket to the receiver through the slots cre-
ated in Step 5. Ensure that the bracket will fit correctly
then remove the three screws and bracket. More foam
may need to be removed to ensure a good fit. PIC 5, 6
and 7 The receiver should fit snugly into the foam slot.
STEP 12 Position the receiver in the seat and pull the seat cover-
ing over the top of the receiver. PIC 9 Place the chrome
top trim over the receiver so the seat covering is be-
tween the top of the receiver and the top trim. PIC 9
PLUG IN DRIVERS BACKREST
INSTALLATION
PIC 6
REMOVE JUST ENOUGH FOAM TO ALLOW FOR RE-
CEIVER TO CONTACT SEAT PAN
PAGE
3
PIC 5
SEAT SHOWN CUT APART FOR REFERENCE ONLY.
THE SEAT COVER
DOES NOT HAVE TO BE RE-
MOVED.
NOTE THE APPROXIMATE ANGLE OF THE RECEIVER INSIDE
THE SEAT FOAM (LIGHT BLUE)
NOTE THE APPROXIMATE LOCATION WHERE
RECEIVER CONTACTS SEAT PAN (DARK BLUE)
NOTE CONTOUR OF SEAT PAN (GREEN)
CUT WITH BLADE FACING AWAY FROM SEAT
HEATER WIRING HARNESS (IF EQUIPPED)
PIC 7 PIC 6
NOTE THE APPROXIMATE ANGLE OF THE
RECEIVER INSIDE THE SEAT FOAM
(LIGHT BLUE)
REMOVE THE LEAST AMOUNT OF SEAT
FOAM AS POSSIBLE TO RETAIN SEAT
CUSHIONING
NOTE CONTOUR OF SEAT PAN
(GREEN)
APPROX. 1/2 INCH
APPROX. 2 INCHES
PIC 8
-cont.-