Kuryakyn 9444 VELOCIRAPTOR FOR VT 1300/FURY - Manual (Page 3)

PAGE
3
STEP 10
Attach the side bracket to the chrome mounting bracket with the included 1/4”-20 X 1/2” Button
Socket Head Cap Screw PIC 6. Attach the bottom of the chrome mounting bracket to the bottom
air cleaner mount on the bike with the stock hardware PIC 5. Attach the L
bracket to the stud using the stock hardware PIC 7. Make sure that the
holes in the bracket line up with the threaded holes in the ring adapter.
Tighten the top stock fastener first, bottom stock hardware next, then the
Button Socket Head Cap Screw on the side bracket. Tighten the Low
Crown Acorn Nuts on the L bracket last.
STEP 11 Locate the velocity stack (chrome cone) from the Velociraptor Assembly.
Install one of the adhesive backed gaskets between the front of the
chrome mounting bracket and the back of the velocity stack (chrome
cone). SEE FIGURE 2, PAGE 4, FOR CORRECT GASKET PLACEMENT.
Line the holes up from the velocity stack through the manifold. As shown
in PIC 8, secure using the three 1/4”-20 x 3/4" Socket Head Cap Screws.
STEP 12
Place the plastic cone inside the velocity stack PIC 9, replace the filter
element PIC 10 and secure with the outer trim ring and mesh screen
PIC 11. Also see Figure 1, Page 4, for an exploded view.
STEP 13 Check all hose connections and tighten all hardware. Rotate the
throttle open and make sure it returns correctly before starting
the motorcycle.
ATTENTION!
It is the installer’s responsibility to
ensure that all of the fasteners
(including preassembled) are
tightened before operation of the
motorcycle. Küryakyn will not
warranty components lost due to
improper installation. Periodic
maintenance may be required.
VELOCIRAPTOR FOR VT 1300
INSTALLATION
-cont.-
PIC 6
PIC 7
PIC 8
PIC 9
PIC 10
PIC 11
USE THESE
THREE HOLES
PLASTIC CONE
FILTER
MESH SCREEN
SIDE BRACKET
GOES BEHIND
CHROME MOUNT
USE STOCK
FASTENER
HERE