Kuryakyn 9444 VELOCIRAPTOR FOR VT 1300/FURY - Manual (Page 2)

PAGE
2
CAUTION! The installation of any high performance air cleaner
and/or exhaust system can cause a “lean” fuel/air
mixture. A “lean” fuel/air mixture can cause engine
overheating resulting in severe engine damage.
Küryakyn recommends having the motorcycle tuned
by a competent technician.
NOTE: Some of our high performance air cleaners extend beyond the stock/OEM
unit to achieve smoother airflow and better performance. Riding position
may be affected.
STEP 2 Remove stock air cleaner assembly.
STEP 3 Remove the rear chrome rocker box/spark plug cover by gently pulling
out on it. It has darts on the back that push into rubber grommets on the
rocker box. Remove the forward bolt from the mount. PIC 1 Set this
aside, it will be reused.
STEP 4 Place the included rubber seal over the mouth of the throttle body. PIC 2
NOTE:
Refering to Figure 2 on Page 4 will assist in assembling this kit.
STEP 5
Install the large hose to the top fitting on the ring adapter and the small
hose to the bottom fitting using the stock hose clamps. Then place the
ring adapter over the mouth of the rubber seal on the throttle body. PIC 2
A little spray lube on the rubber seal may aid in installing the ring
adapter.
STEP 6 Install the side bracket to the location that you removed the bolt from in
Step 3 with the stock hardware. Leave finger tight for now. PIC 3
STEP 7
Insert the included 1/4”-20 X 1/2” carriage bolts through the L bracket
and through the inside of the chrome mounting bracket. Place one of the
included 1/4” lock washers then a low crown acorn on each. PIC 4 Leave
finger tight for now.
STEP 8
Install one of the included adhesive backed gaskets to the front of
the ring adapter. Be sure to line up the holes in the gasket with the
threaded holes in the ring adapter and that the “ears” on the gasket
cover the slots on the ring adapter. SEE FIGURE 2, PAGE 4, FOR
CORRECT GASKET PLACEMENT
STEP 9
Place the chrome mounting bracket over the ring adapter and throttle
body. The slot in the L bracket goes over the exposed stud between the
cylinders. The arm
of the side bracket
goes inside the
chrome mounting
bracket. PIC 5 and
FIG 2
VELOCIRAPTOR FOR VT 1300
INSTALLATION
-cont.-
PIC 1
PIC 2
PIC 3
PIC 5 PIC 4
RUBBER SEAL LARGE HOSE
SMALL HOSE
RING ADAPTER
SIDE BRACKET
L BRACKET ACORN NUTS
CARRIAGE
BOLTS FROM
UNDERSIDE
REMOVE BOLT FROM HERE
USE STOCK
FASTENER
HERE