Kuryakyn 7286 BLACK LED SPEAKER BEZELS - Manual (Page 3)

PAGE
3
BOOM!™ AUDIO TWEETER GRILL INSTALL:
STEP 14 Locate the two (2) #10 X 1-3/8” Pan Head Screws, four (4) #10 X 2-1/4” Pan Head Screws, and
the Spacers in the included hardware kit. Set them within arms reach of the work area.
STEP 15 Align the BOOM!™ Audio Tweeter Grill with the Mounting Plate as shown in PIC 6. Ensure that the
Tweeter fits in the cut out in the Mounting Plate.
STEP 16
Secure the speaker assembly to the inner fairing using the two 2-1/4” screws in the top and
one 1-3/8” screw in the bottom.
DO NOT OVER-TIGHTEN THE SCREWS!
Locate and remove the screw shown in PIC 7; insert one of the included Spacers between the
inner fairing and the metal inner-fairing brace; reinstall the screw.
STEP 17 Repeat STEPS 15 and 16 for the other side.
Move on to STEP 18 or 20 (depending on the model year).
6-PIN ADAPTER FOR ‘00 THROUGH ‘05 MODELS:
STEP 18 Refer to PIC 8. On the front-side of the inner fairing, locate the OEM 6-
pin harness; it is generally located on the
clutch-side. Disconnect the 6-
pin harness.
STEP 19 Locate the included 3-wire 6-Pin Adapter. Apply dielectric grease to each
connector and connect it to the OEM harness.
SKIP TO STEP 22.
TURN SIGNAL PIGTAILS (4-PIN ADAPTERS) FOR ‘06
THRU ’13 MODELS:
STEP 20 Refer to PIC 9. Locate and separate the OEM right turn signal connector (4-
pin). It is located close to the backside of the speaker. There will be one violet
wire, one blue wire and one black wire coming out of the connector.
BLACK LED SPEAKER BEZELS INSTALLATION
PIC 6
BRAKE-SIDE (RIGHT)
BOOM!™ AUDIO
TWEETER GRILL
PIC 7
INNER FAIRING BRACE
REMOVE SCREW, INSERT SPACER
BETWEEN INNER FAIRING AND
BRACE, REINSTALL SCREW
BRAKE-SIDE (RIGHT)
INSERT
SPACER HERE
-cont.-
PIC 9
‘06—‘13 MODELS
4-PIN CONNECTOR
PIC 8
6-PIN CONNECTOR
‘00-’05 MODELS