Kuryakyn 1095 BAHN SHIFT LEVER - Manual (Page 2)

STEP 2 Refer to PIC 1. Measure between the shift pegs and the top plane of the board. Use a non-
permanent marker to mark the angle of the existing shift levers on the end of the shift shaft.
STEP 3 Refer to PIC 2. Remove the existing pinch screws from the shift levers; set
them aside, they will not be reused. Slide the existing shift levers off of the
shift shaft; set them aside, they will not be reused.
NOTE:
Shift lever/peg height is the end user’s preference. Use the marks and
measurements as a starting point when adjusting the position of the levers
on the shift shaft. During installation, ensure proper clearance between the
shifting mechanism and the boards.
STEP 4
Refer to PIC 3. Align the BAHN Shift Lever(s) with the marks and slide the them onto the shift
shaft. Measure the distance to the top plane of the board; remove the levers from the splined
shaft if any adjustments are necessary.
STEP 5 Secure the BAHN Shift Lever(s) on the shaft with the included 5/16”-24 X .875” Socket Head Cap
Screws and Washers.
BAHN SHIFT LEVER INSTALLATION
-cont.-
Working around the sharp edges of the cylinder-head fins exposes
your hands to injury. Wear protective gloves to prevent injury.
PAGE
2
PIC 1
MARK THE ANGLE OF
THE LEVERS ON THE
END OF THE SHAFT
MEASURE BETWEEN
THE PEGS AND THE
TOP OF THE BOARD
PIC 2
REMOVE THE PINCH
SCREW, THEN SLIDE
THE LEVER OFF THE
SHAFT
PIC 3
ALIGN THE LEVERS WITH THE MARKS MADE ON THE
SHAFT, ENSURE THE DISTANCE TO THE BOARD IS
SUFFICIENT, ADJUST IF NECESSARY
SECURE THE LEVERS ON THE
SHAFT WITH THE INCLUDED
5/16” SCREWS AND WASHERS
THE END USER’S SAFETY DEPENDS UPON PROPER INSTALLATION
OF THIS PRODUCT. IF A STEP IN THIS SET OF INSTRUCTIONS IS
NOT WITHIN YOUR CAPABILITIES OR YOU DO NOT HAVE THE COR-
RECT TOOLS, HAVE YOUR DEALER PERFORM THE PROCEDURE. IM-
PROPER INSTALLATION OF THIS PRODUCT COULD RESULT IN
DEATH OR SERIOUS INJURY.