Kuryakyn 5051 L.E.D. RUN-BRAKE STRIP for TRIKES - Manual (Page 3)

PAGE
3
STEP 6
Route the wire harness from the Strip Light along the left taillight wire harness under the body to
the wiring adapter under the seat. Use the provided cable ties to secure the wiring to the taillight
harness and away from any possible pinch points and or moving parts. If the included cord
keepers are used under the trike, clean the location for the cord keepers with the included
alcohol pad before attaching them.
Secure all wiring away from any moving parts, pinch points or extreme heat.
Küryakyn WILL NOT issue a warranty on any electrical component that fails due to
pinched, crimped, broken, abraded, melted or frayed wires.
STEP 7
Connect the three pin connector from the Light Strip to one of the three pin
connectors on the Light Bar Harness. It will not make a difference which connector you use.
STEP 8
Turn the ignition on and test to make sure that the lights function as both running lights and
brake lights. If they do not function, go over all wiring connections.
ENSURE PROPER LIGHTING OPERATION BEFORE RIDING THE
MOTORCYCLE. VISIBILITY IS A MAJOR CONCERN FOR MOTORCYCLISTS.
A LIGHTING MALFUNCTION COULD RESULT IN DEATH OR SERIOUS
INJURY.
STEP 9 After all wires have been secured, replace the seat.
AFTER INSTALLING THE SEAT, PULL UP ON IT TO ENSURE IT IS LOCKED
INTO PLACE. A LOOSE SEAT CAN SHIFT AND CAUSE LOSS OF CONTROL
RESULTING IN SERIOUS INJURY OR DEATH.
UNIVERSAL
INSTALLATION
STEP 10
With the wire harness end of the Light Strip, start on the left (sitting on Trike/motorcycle) side
and test fit the Run-Brake Strip to the mounting area. Make any reference marks with masking
tape or a non-permanent marker.
NOTE: It may be helpful to use masking tape to temporarily hold the Run-Brake Light Strip in
place for the test fit.
NOTE: Examine the light carefully. As shown in PIC 2 on Page 2, notice the markings on the
light specifying the place to cut the light. If you need to shorten the light for your
application, always make your cut from the end of the light opposite the wire leads.
STEP 11
If necessary, the lights may be trimmed to custom lengths (every 2 lights). PIC 2 ON Page 2
Make sure that you make your cut from the end opposite from the wire leads. Kuryakyn
recommends using silicone to seal the cut end to prevent corrosion.
STEP 12
Thoroughly clean the back of the Trike with soapy water and a clean rag. Dry completely. Wipe
the area with the included alcohol pads to remove any residue. Let dry completely.
Ensure the area of installation is free of grease, oil, dirt or other debris including
wax/polish products and bugs to ensure proper adhesion. Küryakyn WILL NOT
issue a warranty on any parts lost due to improper installation.
RUN-BRAKE LIGHT STRIP
INSTALLATION
-cont.-