Kuryakyn 5007 DRIVING LIGHTS FOR ROAD GLIDE - Manual (Page 4)

PAGE
4
STEP 1
For up and down adjustment, loosen the 1/4”-20 fastener that secures the light
assembly to the mount and tilt the assembly in the desired direction. When the
light is in the desired position, tighten the 1/4”-20 fastener securely. PIC 8
STEP 2 For side to side adjustment, follow the light removal procedure, Steps 1 and 2,
below. After removal of the light, loosen the hex fastener (PIC 9), move the
housing to the desired position and retighten the hex fastener securely.
Reassemble the light in the reverse order.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the
motorcycle. Küryakyn will not provide warranty coverage on
products or components lost due to improper installation or lack of
maintenance. Periodic inspection and maintenance are required on
all fasteners.
REPLACING THE LIGHT BULB
STEP 1
Remove the Button Head Cap Screw located at the bottom of the light housing.
PIC 10 Remove the light bezel by twisting the bezel counter clockwise and pulling
the bezel outward. Remove the rubber inner seal from the chrome light housing.
The glass light housing should now be free.
NOTE:
Please note the orientation of the locating ring. This will greatly help
when reassembling the lights. PIC 10.
STEP 2
Pull the glass housing out and disconnect the wires PIC 11.
STEP 3
As shown in PIC 12, remove the 4 screws to gain access to the light bulb.
STEP 4
Pull the light bulb from the mount with the white wire attached.
STEP 5
Take the new light and insert the white wire through the mount from the front
side. (The wire should fit through the rubber boot on the backside of the mount).
Do not handle the glass portion of the new bulb with your bare hands. Oil
from your fingers will stay on the bulb and create a hot spot, shortening
the life of the bulb. If you do touch the bulb, clean it with an ammonia
based cleaner, such as window cleaner or with alcohol before installation.
STEP 6 Reassemble the glass housing and the chrome housing in the reverse order.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the
motorcycle. Küryakyn will not provide warranty coverage on
products or components lost due to improper installation or lack of
maintenance. Periodic inspection and maintenance are required on
all fasteners.
Ride On!
DRIVING LIGHTS/ROAD GLIDE
INSTALLATION
PIC 10
REMOVE THIS SCREW
ROTATE THIS DIRECTION TO REMOVE
THESE UNPLUG
PIC 11
REMOVE THESE SCREWS
LOCATING RING
PIC 12
PIC 8
PIC 9
USE THIS FASTENER
FOR UP AND DOWN
USE THIS FASTENER
FOR SIDE TO SIDE