Kuryakyn 5007 DRIVING LIGHTS FOR ROAD GLIDE - Manual (Page 3)

STEP 8
Repeat STEP 3 through STEP 7 for the left side.
STEP 9
Remove the gauge shroud as described in the service manual. PIC 4
STEP 10
Locate and disconnect the 12-Pin AMP connector in the dash housing. PIC 5
STEP 11 Locate the 12-pin wiring adapter from the wiring kit. Apply some of the included
dielectric grease to each 12-Pin connector and plug it into the OEM AMP
connectors. PIC 6
STEP 12 Route the power wire for the driving lights out under the bottom of the dash,
along the OEM harness beside the neck, to the front of the inner fairing. PIC 7
STEP 13 Apply some dielectric grease to the insulated female spade on the power wire and
connect it to the supplied white “Y” wire. Route the white wires from each driving
light to the up to the “Y” wire that was just connected. Apply some dielectric
grease to each connector on the white “Y” wire and connect one end to the white
wire from each driving light. Secure any excess wiring out of harms way with the
included cable ties.
STEP 14
Place a small amount of dielectric grease on the plug and insert it in the right turn
signal connector where the OEM signal was removed from in STEP 3. Make sure
that the driving lights are supported when these connections are made so the
wires and the driving lights are not damaged.
Secure all wiring from the newly installed and/or from existing
parts, away from any moving parts, pinch points or extreme heat.
Küryakyn WILL NOT issue a warranty on any electrical component
that fails due to pinched, crimped, broken, abraded, melted or frayed
wires.
STEP 15
Reconnect the battery and test that all lights work correctly.
STEP 16 Reinstall the gauge shroud as described in the service manual.
ENSURE PROPER LIGHT OPERATION BEFORE RIDING THE
MOTORCYCLE. VISIBILITY IS A MAJOR CONCERN FOR
MOTORCYCLISTS. A LIGHTING MALFUNCTION COULD
RESULT IN DEATH OR SERIOUS INJURY.
STEP 17
Reinstall the outer fairing as described in the service manual.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the
motorcycle. Küryakyn will not provide warranty coverage on products
or components lost due to improper installation or lack of
maintenance. Periodic inspection and maintenance are required on
all fasteners.
ADJUSTING THE DRIVING LIGHTS
WARNING! IT IS THE INSTALLERS RESPONSIBILITY TO ADJUST THE NEW
DRIVING LIGHTS TO THE PATTERN RECOMMENDED IN THE SERVICE
MANUAL FOR THE LOW BEAM OF THE HEADLIGHTS. FAILURE TO
PROPERLY ADJUST THE LIGHT PATTERN MAY DISTRACT ONCOMING
DRIVERS RESULTING IN SERIOUS INJURY OR DEATH.
PAGE
3
DRIVING LIGHTS/ROAD GLIDE
INSTALLATION
-cont.-
PIC 4
PIC 6
PIC 5
REMOVE GAUGE SHROUD
UNPLUG THIS CONNECTION
PLUG WIRING
ADAPTER IN
PIC 7
ROUTE POWER WIRE