BT 900 - Manual (Page 28)

25
Display briefly shows PLS WAIT then the base
station to which your handset is registered, e.g.
BASE 1, and finally shows the handset number
you have given it, e.g.
HSET 1.
To de-register your handset
• Press the ➔ button several times until the
display shows
SET UP.
• Press the ✔ button. Display shows HANDSET.
• Press the ✔ button. Display shows
LEVEL.
• Press the ➔ button several times until the
display shows
REG.
• Press the ✔ button. Display shows ADD.
• Press the ➔ button until the display shows
REMOVE.
• Press the ✔ button. Display shows PIN= - - - - .
• Enter the four-digit base station code.
(Default 0000. Enter this if the base station
code has not been changed.) The
- - - - marks
disappear one by one.
• Press the ✔ button. Display shows
LABEL=X
(i.e. your handset number).
• Press the ✔ button. You will hear a beep, the
display will show e.g. HSET 2 followed by REG.
• Your handset is now de-registered.
You cannot use the same number on more than
one handset since this disables the intercom
function.
To de-register another handset that is
registered to your base station
Follow the steps opposite ‘To de-register your
handset’ but instead of entering the label of your
own handset, scroll through the options button
➔ until the label of the handset you wish to
de-register is shown.
• Press the ✔ button to confirm. You hear a
confirmation beep.
• The display on the de-registered handset
changes to REG. (Or, if it is also registered
with another base station, the display shows
the handset number for that base station.)
If you are experiencing problems, please call
the Synergy Helpline on
0845 650 20 20 .