Kinetik Blood Pressure BPM1C - Manual (Page 4)

Loading the Batteries
a. Open the battery cover at the back of the monitor.
b. Insert four “AAA” batteries, observing correct polarity.
c. Close the battery cover. If using an external power supply,
ensure that batteries are removed
from battery compartment.
For external power supply, use a
6V600mA DC Adaptor (not
included in this pack)
Replacing Batteries
When the LCD screen displays ‘low battery’ , new batteries must be inserted
immediately to ensure accurate results.
Rechargeable batteries with a voltage of 1.2V are not suitable for this product.
Please dispose of batteries according to battery manufacture’s instructions. Insert the rubber tube plug of
the cuff firmly into the cuff socket
located on the side of the monitor
to ensure there is no air leakage.
The cuff should be ready to
use. Ensure that the end is
passed through the metal loop
and the hook and loop fastening
is facing outwards.
Non-rechargeable batteries are not to be recharged.
Exhausted batteries are to be removed from the monitor.
The supply terminals are not to be short circuited.
Do not mix old and new batteries or different types of batteries. Do not use
rechargeable batteries. Only batteries of the same or equivalent type as
recommended are to be used. Batteries must be handled with care under
adult supervision. If batteries leak and come into contact with the skin or
eyes, wash immediately with copious amount of water.
Setting up your Blood Pressure Monitor
b.
a.
Connecting the Cuff
4
low battery
deflate to measure (deflate air in cuff)
inflate to measure
Pulse
Systolic Diastolic
Cuff
Cuff tubule socket
Rubber tubule
Memory
LCD
Start
Parts
3