KD Scientific 310 - Manual (Page 6)

4
KDS Model 310 Plus Series KDS Model 310 Plus Series
Keypad Functions
This key has two functions:
a. Moves the display to the left
b. Causes the numerical entry to decrease. To change the displayed number
by a single unit press and release the key quickly. If the key is pressed longer
the number changes with increasing speed.
This key has two functions.
a. Moves the display to the right
b. Causes the numerical entry to increase. To change the displayed number by
a single unit press and release the key quickly. If the key is pressed longer the
number changes with increasing speed.
➔
➔
Features
The Model 310 Plus is an infusion/withdrawal syringe pump designed to hold glass syringes
[Hamilton] from 1 to 250 microliters.
Setup and pump operation is extremely simple. A menu, displayed on an alphanumeric LCD
"prompts" the operator to make the necessary selections using the keypad for choice of
features and numerical entries.
The internal diameter of the syringe is used by the control program to calibrate the pump
and deliver the volume and flow rate selected. For simplicity the syringe diameter is also
used to set automatically the volume and flow rate units.
The syringe diameter can be entered directly or the syringe can be identified from a table
of syringes held in memory. When the syringe is selected from the table the diameter is
entered automatically.
Two dispense modes are available:
a) Dispense volume mode in which the pump keeps track of the volume dispensed
and automatically stops the pump when a set target volume is reached.
b) Run mode where the pump runs at the set flow rate until manually stopped.
In the event of a power interruption during operation, the pump can be programmed to
either resume operation or remain stopped when power is returned.
For convenience, all pump settings are stored in non-volatile memory to minimize the
number of setting changes required.
Important:
The KDS 310 Plus injector and controller are not interchangeable with the KDS 310.