JULABO FPW50-HE Refrigerated and Heating Circulators - Manual (Page 4)

4
9.2. MENU PROGRAM – creation, administration ..........................................................43
9.3. MENU PUMP - Setting of pump pressure ...............................................................45
9.4. MENU CONFIG - Configuration of unit ....................................................................46
9.4.1. Remote control via the serial interface ................................................................47
9.4.2. Keypad control or setpoint setting via the analog input .......................................48
9.4.3. AUTOSTART ......................................................................................................48
9.4.4. OFF-MODE ........................................................................................................49
9.4.5. ACTVAR - actuating variable ..............................................................................49
9.4.6. Setting of clock and date ....................................................................................50
9.4.7. RESET – Factory settings...................................................................................50
9.5. MENU CONTROL – Control characteristics and parameters...................................50
9.5.1. CONTROL – Control INTERNAL / EXTERNAL ...................................................52
9.5.2. SELFTUNING .....................................................................................................53
9.5.3. Dynamic internal .................................................................................................53
9.5.4. Control parameters– XP-, TN-, TV- INTERNAL ..................................................54
9.5.5. COSPEED - external ..........................................................................................55
9.5.6. Control parameters – XPU-, XP-, TN-, TV- EXTERNAL ......................................55
9.6. MENU SERIAL - BAUDRATE, HANDSHAKE, PARITY ...........................................56
9.7. MENU ATC - Absolut Temperature Calibration .......................................................57
9.7.1. ATC SENSOR - INTERNAL / EXTERNAL ..........................................................59
9.7.2. ATC STATUS - YES / NO ...................................................................................59
9.7.3. CALIBRATION TYPE: 1 -/ 2 -/ 3 POINT..............................................................60
9.7.4. Example: 3-point calibration for internal control .................................................61
9.8. MENU LIMITS .........................................................................................................63
9.8.1. Limits for internal control .....................................................................................64
9.8.2. Limits for external control ....................................................................................64
9.9. MENU IN/OUT – Analog inputs/outputs (Option) .....................................................66
9.9.1. Outputs of the connector - REG+E-PROG ..........................................................69
9.9.2. Input of the connector - REG+E-PROG ..............................................................70
9.9.3. ALARM-output / Stand-by-input ..........................................................................72
10. Troubleshooting guide / error messages ......................................................................74
11. Electrical connections ..................................................................................................77
12. Remote control ............................................................................................................79
12.1. Setup for remote control ..........................................................................................79
12.2. Communication with a PC or a superordinated data system ...................................79
12.3. List of commands ....................................................................................................80
12.4. Status messages ....................................................................................................83
12.5. Error messages .......................................................................................................83
13. Installation of electronic module ...................................................................................84
14. JULABO Service – Online remote diagnosis ................................................................85
15. Cleaning / repairing the unit .........................................................................................86