I.R.I.S. 130 - Manual (Page 19)

IR / White Light
Auto Mode (IR Version Only): The default IR mode is auto. Auto mode can also be activated via preset 22. In this mode,
preset commands 30~33 are disabled.
When the camera module is in mono, the camera will automatically turn on IR lights. The high beam and low beam will
be turned on/off as per the current zoom levels.
When the module is in color mode, the camera will automatically turn off IR lights.
Manual Mode: Call Preset 21 to turn on the manual mode. The module will be switched into color or mono mode. And
lights can be controlled via the commands of presets 30~33.
Soft Address
The camera address can be changed via presets 62 and 63. The new address will take effect after the camera is
rebooted.
Digital Noise Reduction
This function is set to OFF as default.
When the camera is in color mode, it is recommended to turn off the function, or there will be distortion to the video
image in the form of ‘trails’.
When the camera is in mono mode, call preset 27 to turn on/off the function. There are 1~5 steps from low to high. The
higher the level, the greater risk of distortion.
Wiper
Only activate the wiper when the lens window is wet. Failure to do so could result in the wiper blade prematurely wearing
out and the wiper itself scratching the lens window.