Preparation – I.R.I.S. 130 User Manual
Page 10
3. PREPARATION
This section contains detailed instructions for installing the camera. These instructions assume that the installer has a
good knowledge of installation techniques and is capable of adopting safe installation methods.
3.1. DIP SWITCH SETTINGS:
Factory defaults for the cameras address and communications settings are as follows:
The camera can detect and auto program its protocol (Pelco D, Pelco P) as well as baud rate (2400bps, 4800bps,
9600bps, 19200bps).
Only the camera address setting is necessary. There are two ways to program camera address:
Soft address: via special preset functions (see Section 5.1 Special Control Panel Commands)
DIP Switch: The switches to configure these settings are located on the main board inside the camera. See Fig. 1: DIP
Switch.
Fig.1: DIP Switch:
Details of how to set the camera address can be found in Section 7.
Please note, the camera will require rebooting after the address is set via DIP switches in order to activate the new
address setting.