Hydro-Logic StealthRO200 - Manual (Page 10)

then be re-used. If the tube has been removed several times you may see
Push In/QuickConnect Fittings
&RQQHFWLQJ 3XVK,Q )LWWLQJV
Push tubing firmly into the fitting, all the way to tube stop. The collet
(gripper) has stainless steel teeth which hold the tube firmly in position
while the 'O' Ring provides a permanent leak proof seal. Pull tubing to
check for security. If some tube pulls out, then push all the way in again
until it stops. It is good practice to test the system prior to leaving site
and/or before use.
'LVFRQQHFWLQJ 3XVK,Q )LWWLQJV
Ensure system is depressurized before removing fittings. Push in the collet
evenly against the face of the fitting. With the collet held in this position
the tube can be removed by simply pulling. You can use a collet release
(available from your dealer) or small crescent wrench. The fitting can
score marks on the ends, this can lead to leaks. It is best to cut the end off of the
tubing with a sharp blade being careful to cut straight across; any angle
to the cut can prevent an improper fit in the collet.
Filter Changes / Maintenance
It is essential that you change your pre-filters regularly. The green carbon
filter has a rated life of approximately 1,250 gallons* of purified water
produced. The sediment filter can be cleaned at your faucet or with a
garden hose as often as you like. You should change the sediment filter at least
once a year or sooner if you have extremely dirty water.
*2,000 gallon filter life with KDF85 carbon filter
tool
youtu.be/EhWXj6DWcH0
/LQN 7R ,QVWUXFWLRQ 9LGHR