Hydro-Logic 1/4 FLOW MASTER Digital Flow Meter - Manual (Page 2)

FLOW MASTER Programing Example
WARNING:
1. This product is pressure sensitive. Changes in water pressure can cause damage.
Install the Flowmaster on product (purified water) line only!
2. Make sure the flow of water is going in the direction of the arrows on the Flowmaster.
3. DO NOT remove battery while LCD screen is active.
4. Begin by running a low flow of water through the Flowmaster until the entire
unit fills with water. Do not start with a high flow rate.
5. The 1/4” Flowmaster is designed to operate between 0.01 - 0.5 Gallons Per Minute
1. Below is an example of how to program the Flowmaster for the Stealth-RO200. We will
program a capacity of 2,000 gallons for this example.
2. Press the “Filter” button. Press the “Setting” button. Press the ”Filter” button until the lower right
hand side of the display flashes “Gallon”. Press the “Setting” button four times, until the last digit
from the left flashes. Press the “Filter” button until it reads “2”. The four digits should now read
“2000”. The “Gallon” readout should also be visible in the lower right hand corner. You have now
successfully programmed your Flowmaster for 2,000 gallons. Once it reaches that capacity, it will
beep, alerting you to replace the filters and reset the Flowmaster.
Hydro-Logic Purification Systems
370 Encinal Street, Suite 150
Santa Cruz, CA 95060
ph: 888.426.5644
fax: 831.336.9840
www.hydrologicsystems.com
Setting
Button
P U R I F I C A T I O N S Y S T E M S