Service, Warranty, Parts and accessories – HMC Electronics ESL300 Delta Regis Electric Screwdriver, Direct Plug-in User Manual
Page 6
120/220VAC Direct Plug-In
Operation Manual
Page 6
Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified
1.
personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Use of unauthorized parts or failure to follow maintenance
2.
instructions may create a risk of electric shock or injury.
Check for damaged parts. Before further use, any part that is damaged should be carefully checked to determine that it
3.
will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts,
breakage, and other conditions that may affect the tools’ operation. A part that is damaged should be properly repaired
or replaced by an authorized service center. Do not use the tool if the switch does not turn it ON or OFF.
Screwdrivers should be maintained in top running condition and used no more than 8 hours per day. To avoid motor
4.
overheating, do not drive more than 10-15 screws per minute.
It is recommended that the screwdriver be serviced and carbon brushes be changed every five to six months. Brushes
5.
should be replaced when 1/3 of the original length has worn away (2-3 mm, depending on the model). Life of the
brushes depends on operating frequency and torque output.
Inspect cables for signs of wear and have them replaced if suspect. Using an ohmmeter, verify ground continuity from
6.
the tip of the screwdriver bit holder to the ground pin connection on the power cable.
If the screwdriver is used more than 8 hours per day, service should be performed more frequently.
7.
Do not remove any labels. Replace labels which have been damaged.
8.
Repairs to Delta Regis AC Direct Plug-In Series Screwdrivers must be performed by trained personnel, knowledgeable and
qualified in the repair of electric screwdrivers. Consult your nearest Delta Regis authorized service center.
Use only genuine Delta Regis parts when servicing these products. Do not attempt to modify the tools.
It is the responsibility of the employer to inform all operators of the information in this manual.
Service
Delta Regis AC Direct Plug-In Screwdrivers are warranted for one year from the date of purchase against defects in material
and workmanship. This warranty does not cover damage due to transportation, abuse, misuse, or improper service. Our sole
remedy is to repair or replace (at our discretion) any unit found to be defective due to defects in material or workmanship.
It is the responsibility of the user to return any product thought to be defective, freight prepaid, to our warehouse for
inspection and evaluation.
There is no warranty of merchantability or fitness of purpose. In no event will Delta Regis Tools, Inc.
be liable for business interruptions, loss of profits, harm, injury, damage, personal injury, cost of delay,
or any other special, indirect, incidental, or consequential losses, costs, or damages.
Warranty
If you require parts or accessories for your Delta Regis product, please refer to our website or contact us for further
information.
Parts and Accessories
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440