Screwdriver overview – HMC Electronics ESL300 Delta Regis Electric Screwdriver, Direct Plug-in User Manual
Page 3
120/220VAC Direct Plug-In
Operation Manual
Page 3
Screwdriver Overview
Tool Use and Care
Use clamps or other practical means to secure and support the workpiece to a stable platform. Holding the work by
1.
hand or against your body is unstable and may lead to loss of control.
Do not force the tool. Use the correct tool for your application. The correct tool will do the job better and safer at the
2.
rate for which it is designed.
Do not use the tool if the switch does not turn it on or off. Any tool that cannot be controlled with the switch is
3.
dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments, changing accessories, or storing the tool.
4.
Such preventative safety measures reduce the risk of starting the tool accidentally.
Store idle tools out of reach of children and untrained persons. Tools are dangerous in the hands of untrained users.
5.
Maintain tools with care. Check for misalignment or binding of moving parts, breakage of parts, and any other
6.
condition that may affect the tool’s operation. If damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools.
Use only accessories that are recommended by the manufacturer for your model. Accessories that are suitable for one
7.
tool may become hazardous when used on another tool.
Operating Cautions
When changing a screwdriver bit or changing accessories, make certain that the forward/reverse switch is in the ‘OFF’
1.
position and the tool is unplugged.
Do not allow chemicals such as acetone, benzene, thinner, trichloroethylene ketone, or other similar chemicals to
2.
come in contact with the screwdriver housing as damage will result.
Do not drop or abuse the screwdriver.
3.
Do not adjust the torque setting higher than 8 on the torque scale.
4.
This tool is intended for a duty cycle of 0.8 sec ON and 3.2 sec OFF.
5.
Do not tighten more than 800 tapping screws per hour (M3 x 5mm).
6.
This screwdriver is not intended to drive wood screws.
7.
Do not operate the forward/reverse switch while the screwdriver is running.
8.
Whenever a tool is not being used, move the forward/reverse switch to the OFF position and unplug the power cord.
9.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440