Important - safety and use – HMC Electronics ESL300 Delta Regis Electric Screwdriver, Direct Plug-in User Manual
Page 2
Work Area
Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
1.
Do not operate power tools in explosive environments, such as in the presence of flammable liquids, gases, or dust.
2.
Power tools create sparks which may ignite the dust or fumes.
Keep bystanders away while operating a power tool. Distractions can cause the operator to lose control.
3.
Electrical Safety
Use only the correct electrical outlet for the screwdriver power cord plug. Grounded tools must be plugged into an
1.
outlet properly installed and grounded in accordance with all codes and ordinances. Never remove the grounding
prong or modify the plug in any way. Do not use an adapter plug.
Avoid body contact with earthed or grounded surfaces such as pipes, metal structures or other electrical products.
2.
There is an increased risk of electrical shock if your body is grounded.
Use these products in a suitable dry, indoor location. Do not use the tool in damp, wet or high temperature
3.
environments. Water entering a power tool will increase the risk of electrical shock.
Ensure that the supply outlet is overload protected and of sufficient amperage capacity.
4.
Don’t abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet by the cord. Keep the cord
5.
away from heat, oil, chemicals, sharp edges, and moving parts. Replace damaged cords immediately. Damaged cords
increase the risk of electrical shock.
When operating a power tool outdoors, use an extension cord suitable for outdoor use.
6.
Personal Safety
Stay alert, watch what you are doing, and use common sense when operating a power tool. Do not use tools when
1.
tired or under the influence of drugs, alcohol, or medication. A momentary lack of attention while operating a power
tool may result in serious personal injury.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep hair, clothing, and gloves away from
2.
moving parts. Loose clothing, jewelry, or long hair can be caught in moving parts.
Avoid accidental starting. Make sure the trigger switch is off before plugging the tool in. Carrying tools with the
3.
trigger held on or plugging in tools with the trigger switch on invites accidents.
Remove adjusting keys or wrenches before turning on the tool. A wrench or key that is left attached to a rotating part
4.
of the tool may reult in personal injury.
Do not overreach. Keep a proper footing and balance at all times. Proper footing and balance enables better control of
5.
the tool in unexpected situations.
Use safety equipment. Always wear eye protection. Dust mask, non-slip safety shoes, hardhat, or hearing protection
6.
must be used for appropriate conditions.
120/220VAC Direct Plug-In
Operation Manual
Important - Safety and Use
Warning - Read all instructions. Failure to understand and follow proper guidelines, safety
requirements, and operating instructions may result in malfunction, component damage, property
damage, shock hazard, fire hazard, injury or death. The term ‘power tool’ refers to a mains operated
(corded) or battery operated (cordless) electric screwdriver. Save this manual for future reference.
Grounding - This screwdriver’s AC power cord is equipped with a 3-prong electrical plug with ground pin. The plug must
be connected to a properly grounded AC electrical outlet. Do not attempt to use this screwdriver without a properly
functioning ground connection. Never connect a live circuit to the ground pin or internal green or yellow-green ground
wire.
Page 2
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440