HiRO H50113 V92 56K User Manual
Page 31

Hiro H50113
30
Q
and displayed on the monitor. Basic result codes
include OK, CONNECT, RING, NO CARRIER, and ERROR. Use
the
Q
result code generation by the modem. If result codes are disabled
and an invalid parameter value is entered, the
modem does not generate an ERROR result code because result
codes are turn off.
Result codes:
_ OK if
_ ERROR if
≠0—1.
T—Select Tone Dialing
Use this command to configure the modem for DTMF tone dialing.
All subsequent D
tone dialing until either the P command or a pulse dial modifier is
received by the modem. Tone dialing is the default setting. This
command does not use parameters and generates an ERROR
result code when parameters are attached to the command.