HiRO H50083 V92 56K User Manual
Page 9

9
H - Disconnect (Hang-Up)
This command initiates a hang up sequence. This command may not be available for some countries
due to PTT restrictions.
Syntax
H[
Defined Values
0 The modem will release the line if the modem is currently on-line.
1 If on-hook, the modem will go off-hook and remain in command mode.
Result Codes
OK
ERROR Otherwise.
O - Return to On-Line Data Mode
This command specifies that the modem will enter the on-line data mode from the on-line command
mode with or without a retrain. If in the off-line command mode when this command is entered, the
modem reports ERROR.
Syntax
O[
Defined Values
0
Enters on-line data mode from the on-line command mode without a retrain. Handling is
determined by the Call Establishment task. Generally, if a connection exists, this command
connects the DTE back to the remote modem after an escape (+++).
1
Performs a retrain then enters on-line data mode from the on-line command mode.
Result Codes
OK
ERROR Otherwise or no connection exists