HiRO H50083 V92 56K - Manual (Page 13)

13
V.92 +P and –Q Commands
This section describes the +P (PCM DCE) and –Q commands and parameters used to control the
V.92 Mode operation.
+PCW - Call Waiting Enable
This command controls the operation of the modem in the presence of call waiting.
Syntax
+PCW=
Defined Values
Decimal number corresponding to the selected operation.
0 Request modem-on-hold if enabled by +PMH and collect caller ID information if enabled by
+VRID. Toggle V.24 circuit 125. (Default.)
1 Hang-up.
2 Ignore call waiting.
Result Codes
OK = 0, 1, or 2.
ERROR Otherwise.
Reporting Selected Value(s)
Command: +PCW?
Response: +PCW:
Example: +PCW: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PCW=?
Response: +PCW: ( range)
Example: +PCW: (0,1,2)