GAM GAMSPIN TSPS80 - Manual

GAM Product #TSPS80
Rosco Product #205 71480 0120
PRODUCT NUMBER
TSPS80 / 205 71480 0120
Gamspin Power Supply - 120 Volt only
TSPS82 / 205 71482 0240
Gamspin Power Supply - 230 Volt only
Page 1 of 1 www.rosco.com
Indexing Rotator PSU
PRODUCT SPECIFICATIONS
PRODUCT DESCRIPTION
The GAMSpin™ indexable power supply provides power
and the control signal for up to 8 GAM Indexable Twin-
Spin™ or SX4® Gobo Tray units. Please see separate
instructions for their operation.
The GAM indexable TwinSpins™ have 8 modes of
operation which are controlled by and require a DMX-
512 signal. In addition there are four, pre-programmed,
stand-alone modes (0,5,6 & 7) that require only a 24
volt supply and no control signal.
The GAMSpin™™ Power Supply Unit (PSU) powers the
TwinSpins™ via the 4-pin XLR output. The control signal
is fed into the power supply and re-routed to the output
connector.¹ Up to 8 units can be powered by one PSU
via a “daisy chain” - each unit in series using the input
and output connectors on the individual rotators (as is the
practice with all DMX controlled equipment). Use 4-wire,
4-pin XLR cable.² Connect the PSU to the first rotator,
then use the output from the first to feed the second, and
continue the “daisy chain” through any additional units.
Connect the DMX signal to the PSU input using standard
DMX czable (5-wire, 5-pin XLR).
You may connect the DMX-512 thru to other PSU’s, dim-
mers or color changers if needed.
Power Requirements 120 Volts AC, 4 Amperes
(230 volt model available)
Non-Dim circuit
DMX-512 Signal Input Standard 5-pin male XLR
DMX-512 Signal Feed Thru Standard 5-pin female XLR
Power Out² 4-pin XLR
Capacity 8 Indexable TwinSpins™
and/or SX4® Gobo Trays
¹Except for this re-routing and protection
circuitry, there is no processing of the DMX
signal. All decoding of the digital signal is
accomplished within the Indexable Twin-
Spin™ Unit or SX4® Gobo Tray Unit.
²Use only cable that has heavy gauge
(#14) conductors for power (pins 1 & 4),
and lighter gauge for the signal (pins 2
& 3). The heavy gauge is most important
with long cable runs and if the “daisy
chain” is fully loaded. This style cable is
similar to standard color changer cable.
Rotators
On/Off AC Fuse
4A
DMX - 512 DMX - 512
INPUT THRU
To Main
Power
From DMX Control
(5-wire cable)
To Other DMX
Devices
(5-wire cable) 4-Wire
Cable
2
Pin 1- 24 Volt DC Pin 3 - DMX signal, re-routed
Pin 2- DMX signal, re-routed Pin 4 - +24 V DC