EUCHNER MGB (V2.0.0) - Manual (Page 6)

MGB Help for Setup and Service
2.2 Teaching in handle module
1. Insert bolt tongue into the evaluation module.
2. Switch on operating voltage UA and UB.
 In case of AR configuration: The green LED (State) flashes quickly (approx. 5 Hz).
A self-test is performed during this time (approx. 8 s).
 If the red LED (DIA) is illuminated, there is a fault. Teach-in is not possible. The green LED (State)
indicates the fault code. Refer to the “System status table” in the respective system manual for
diagnostics.
3. Activate guard locking (only MGB-L1/MGB-L2).
MGB-L1: no voltage at IMP.
MGB-L2: voltage at IMP.
 Teach-in operation starts, green LED (State) flashes (approx. 1 Hz). The teach-in operation is completed
after approx. 60 seconds, the green LED (State) goes out.
4. Switch off operating voltage UB (min. 3 seconds).
 The code of the handle module that was just taught in is activated in the evaluation module.
5. Switch on operating voltage UB.
 The device operates normally.
Page 6/14 Subject to technical modifications 115218-01-03/12