Eschenbach Optik iFlex - Manual (Page 29)

iFlex User Manual Rev 1.0 English
- 29 -
The settings of phase and position are stored for
one particular mode of video input only. So for
example, presume you normally use 800 x 600
video at 60Hz and you have adjusted the iFlex to
suit, then the settings will be saved for this mode
and re-used each time you are displaying this
particular mode. Assume you exit to a DOS
screen and readjust either of the phase or
position controls, then the phase and position
settings for the new (DOS) mode overwrite those
of the previously saved (800x600) mode. When
you return to the 800 x 600 mode, the iFlex will
resort to its internal defaults for this mode.
Refer to Sections 6-2 and 7-4 above for details
on how to configure the iFlex for Computer Video
mode.