Eschenbach Optik iFlex - Manual (Page 22)

iFlex User Manual Rev 1.0 English
- 22 -
If, for some reason, you cannot see the menu to
choose Factory Defaults then perform the
following sequence of button presses:
Power the unit off then on again. Wait for a few
seconds to allow the start-up sequence to
complete.
• Press and hold the mode button until
the beep is heard.
• Press Zoom-Up once.
• Press Focus once.
• Press the middle function button and the
factory defaults should be restored.
7. Advanced Functions
It is possible to select and assign one of the
advanced functions to the three function buttons
on the front panel and to the footswitch that
plugs into the back of the iFlex. The functions
are assigned by using the Button Functions
option of the Configuration Menu described
above in section 6-2.
Please try out the available functions and then
decide which ones suit your needs most.