Enerpac BRP-302 - Manual (Page 2)

IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. If any shipping damage is found,
notify carrier at once. Shipping damage is
NOT covered by warranty. The carrier is
responsible for all repair or replacement costs resulting from damage in shipment.
DESCRIPTION Enerpac Pull-pac cylinders use hydraulic pressure to produce a pulling or tensioning
force. Typical applications include tension testing, weight measurements, tightening
tension lines, or as a replacement for conventional ratchet cable pullers, in situations
where high force is needed over a short stroke.
SAFETY
INFORMATION
To avoid personal injury or property damage during system operation, read and follow
all
CAUTIONS , WARNINGS , and INSTRUCTIONS included with or attached to each product.
ENERPAC CANNOT BE HELD RESPONSIBLE FOR DAMAGE OR INJURY RESULTING FROM
UNSAFE USE OF PRODUCT, LACK OF MAINTENANCE, OR INCORRECT PRODUCT AND
SYSTEM APPLICATION . Contact Enerpac when in doubt as to applications and safety
precautions.
WARNING
DO NOT DISASSEMBLE THE CYLINDER. The stop ring is spring loaded
and could cause serious personal injury if the cylinder is not
disassembled properly. For repair service, contact the authorized
Service Center in your area.
WARNING
To avoid personal injury, always wear proper personal protective gear
when operating hydraulic equipment (i.e. safety glasses, gloves, etc.).
WARNING
The system operating pressure must not exceed the maximum pressure
rating of the lowest rated component in the system.
WARNING
Never overload the cylinder. Pulling a load that exceeds the capacity of
the cylinder may cause equipment failure and serious personal injury.
WARNING
Make sure that all system components are protected from external
sources of damage, such as excessive heat, flame, moving machine
parts, sharp objects, corrosive chemicals. DO NOT expose equipment to
temperatures of 150°F (65°C) or more.
CAUTION
DO NOT use the hydraulic hose to carry or drag a hydraulic component,
because damage the hose or the component may occur.
CAUTION
Use less than the maximum rated stroke. Operating the cylinder beyond
the limits of its rated stroke can damage the cylinder.
2