ElmoMC Gold Line Digital Servo Drives-Gold Tuba Cable Kit - Manual (Page 18)

Gold Tuba Cable Kit (EtherCAT and CAN)
MAN-G-TUB-CBLKIT (Ver. 1.000)
www.elmomc.com
18
Chapter 8: 24 VDC Auxiliary Supply
The 24 VDC auxiliary supply is a single 24-AWG double-shielded twisted-pair cable. It is
connected to the Gold Tuba VL connector on the servo drive side.
The cable is open on the end side so that it can be connected to the power supply.
The general pinout of the 24 VDC auxiliary supply is as follows:
Pin
No.
Signal Color Twisted &
Shielded Wire
VL+ +24VDC Red
Pair
VL- 24VDC_RET Black
Pin Positions
2-Pin Pluggable 3.81 mm Phoenix Connector
2-Pin Phoenix Plug-in
Connector
Note: The specific functionality of each pin is described fully in the Gold Tuba Installation
Guide.
Figure 4: 24 VDC Auxiliary Supply Cable