Dreams Selkirk Bedstead - Manual (Page 6)

Slide the side rail (04)
and threaded stud (13)
into the locating tube
on the cross rail (05).
Fit the nut (15) and
finger tighten the nut at
this stage. Repeat for
other 3 corners
2’6” & 3’ Frame
Fit the slats. With the bow of the slat
facing upwards slide one end of the
slat (08) into the slat holder located in
the side rail.
Then slip the other end of the slat
into slat holder in the opposite
side rail.
Fit the extension
legs to the ends of
the headend 01 as
shown
This stage is for beds
with castors. Castors
are optional and are
not supplied if not
ordered as options.
Remove plastic cap
from the end of the
legs. Insert the the
castors.
1 2
3 4
5
Fit four threaded studs (13)
( the short thread in the side
rail) to each end of the two
side rails (4)
8
9
This stage
may require
two people.
Remove the
screws and washers
from the headend
(01) and footend (02) .
Then, using these fittings,
attach the frame to the
headend and footend at
either of the two height
positions.
Fit the centre cross bar (06)
with flat head screw (16) and
nut (15) to center of one side
rail (04) . Repeat for the other
end of center cross bar.
If the style of Bedstead
or Headboard has
knobs, Screw knobs
to top of headend and
footend. using the
stud provided