beautypg.com

Universal frame – Dreams Selkirk Bedstead User Manual

Page 5

background image

1

2

3

4

5

6

Fit the extension

legs to the ends of

the headend 01 as

shown

Slide the side rail (04) and
threaded stud (13) into
the locating tube on the
cross rail (05). Fit the nut
(15) and finger tighten the
nut at this stage. Repeat
for other 3 corners

This stage is for
beds with castors.
Castors are optional
and do not have to
be fitted. Remove
plastic cap from
the end of the
legs. Insert the the
castors.

Fit four threaded studs
(13) ( the short thread
in the side rail) to each
end of the two side
rails (4)

Fit the two threaded studs
(14)to center of the two
end cross bars (05)
Screw on the nut (15) to
the stud but do not tighten

Fit the centre cross bar (06)
with flat head screw (16) and
nut (15) to center of one side
rail (04) . Repeat for the other
end of center cross bar.

Universal Frame

7

8

9

10

11

12

Fit the center
rail(07) by sliding
the U groove over
the the threaded
stud (14) located
in the center of the
end cross bar (0).
Repeat for the other
end of the center
rail .

Remove center slat cap
of center rail (07). Align
the center rail (07) over
center cross bar (06) and
fit with CS screw (17)
and nut (1)

Tighten all the fitttings in the
slatted frame. Fit the slats.
With the bow of the slat facing
upwards slide one end of the slat
(08) into the slat holder located in
the side rail (04).

Remove slat cap from the center
rail and slide other end of slat into it
Repeat this for the opposite slat in the
opposite rail. Then position the center
slat cap over the center rail (07) and
push down firmly in place. Repeat for
all the slats.

This stage
may require
two people.
Remove the
screws and washers
from the headend (01)
and footend (02) . Then,
using these fittings, attach
the frame to the headend
and footend at either
of the two height
positions.

If the style of

Bedstead or

Headboard has

knobs, Screw knobs

to top of headend

and footend. using

the stud provided