Dreams Barcelona TV Bed - Manual (Page 7)

motor of the TV Lift... this is normal and is nothing to be concerned about - it is a feature to protect the controller
system.
THEN press UP button TWICE, to raise the TV lift. Pressing the button in this sequence “wakes” the controller from
1
4
3
2
Changing the batteries in the remote switch
Tool Requirement : Small Crosshead screwdriver.
Carefully follow these instructions to re-place the batteries ;
Step 1: Remove screws (D) and take the switch (I) out of the side panel.
Step 2: Turn switch over & slide off the battery cover.
Step 3: Slide out the round case holding the batteries.
Step 4: From round case take out the three batteries noting
the way they are placed.
Change all three batteries taking care to make su re +
sides remains pointing upwards.
Test the switch - you can do this outside the side panel of the bed.
Battery specification : CR 2016 x3
Page 7 of 7
D
I
Re - insert into plastic case and slide back into position
in the switch. Make sure + side is upwar
d touching the
+ mark on the terminal.
When tested, re-place in side panel the correct way round.
Note, the remote switch and controller have a self protection (A) & child-safety feature (B).
(A) If buttons are pressed in quick succession, you may need to press UP or DOWN button twice to operate the
(B) If TV lift has been down in the rest position for a few minutes, it will be necessary to press DOWN button once,
child safety mode, then it will operate normally.