New Buck Corporation 32 - Manual (Page 10)

FREESTANDING INSTALLATION
MODEL 32 (FS)
1. Determine the exact location of your gas heater.
NOTE: Due to high temperatures, this heater should be located out of traffic areas and away
from furniture and draperies.
NOTE: For safe installation the minimum clearances must be met. See Figure 2. For floor
protector, see last paragraph, page 8.
CAUTION: THE INSTALLATION MUST CONFORM TO LOCAL CODES. IN THE
ABSENCE OF LOCAL CODES, INSTALLATION MUST CONFORM WITH THE NATIONAL
FUEL GAS CODE,ANSI Z223.1/NFPA54.
NOTE: See page 17 for “Gas Connection” and page 18 for “Pressure Check”.
2. Check gas type. Use only the type of gas indicated on the valve rating plate. If the type of gas listed
on the plate is not your type of gas supply, DO NOT INSTALL. Contact your dealer for proper
model. Position logs as shown on page 16. Position screen before leaving heater unattended.
WARNING: YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN THEY
ARE IN THE SAME ROOM AS THE HEATER. DO NOT PLACE CLOTHING OR OTHER
FLAMMABLE MATERIAL ON OR NEAR THE HEATER.
NOTE: When the appliance is installed directly on carpeting, tile or other combustible material, other
than wood flooring, the appliance shall be installed on a metal or wood panel extending the full width
and depth of the appliance.
Optional Pedestal (Part#FAP11) Instructions: Lay the heater on its back (use a drop-cloth to protect
the back of the heater and the surface of your flooring). Place pedestal against the bottom of the heater.
Center pedestal from left to right and from front to rear. Mark the holes on the angle of the top of the
pedestal onto the bottom of the heater. Lay the pedestal aside.
Drill the marks made onto the heater with a 1/8” bite (not pro-
vided). Replace the pedestal and secure with the screws pro-
vided. Next stand the heater to the upright position. Place the
heater in the desired location following the clearances above in
figure 2. Note: At this point you may need to secure the pedes-
tal to the floor with screws or an “ell” bracket (not provided)
for safety concerns. Next hook up the gas supply line follow-
ing the instructions in this manual completely.
NOTE:
DIMENSIONS SHOWN ARE
MINIMUM CLEARANCE TO
COMBUSTIBLE WALL.
4"
5"
4"
4"
WALL WALL
STOVE
STO
VE
Figure 2
NOTE: Clearance form
top of appliance to ceil-
ing is 42”. (Not shown
in figure 2)
Page 8