Dascom TallyCom III 2440/2540 Quick Installation Guide - Manual (Page 7)

IP address
The IP address, subnet mask and gateway address can be set
in the menu of the printer via the control panel.
Printer LEDs
The LEDs of the Ethernet signal different modes.
• Yellow only: The LED will blink once every second
until an IP address is assigned. The LED blinks faster or
lights constantly, if there is an error. If this is the case,
check cables and restart the TallyCom III™.
• Green only: TallyCom III™ is receiving data from the
network.
• Yellow and Green: Lights up shortly at power on.
Blinks when resetting to factory default.
Reset the Ethernet interface
To clear all settings to factory default you must ensure that
TallyCom III™ is powered on and hold the TEST button down
until the LEDs blink (~ 8 seconds).
Printing test page
Ensure that the printer is powered on. Press the TEST button
down for about 1 second.
Printer starts to print the print server’s test
page.