Beko WMI 71641 - Manual (Page 25)

EN 25
Preparation
1. Turn the tap on completely. Check that
the hose is connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the “On/Off” button.
2. Select the Programme and the
temperature.
3. If desired (according to your machine’s
model):
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press “Start/Pause/Cancel” button.
The display shows the time remaining for
the Programme to complete if time delay
is not set.
The display shows the time remaining for
the Programme to start if the time delay is
set.
6. Check if the Door Locked Symbol
lights up on the screen.
The Door Locked Symbol (Figure 3-2i) will
light up if time delay is not set.
The Door Locked Symbol (Figure 3-2i) will
fade if time delay is set.
Cancelling a Programme
1. Press and hold the “Start/Pause/
Cancel” button for about 3 seconds;
the Start symbol will start flashing.
2. The machine can discharge all the
water or can take in water for 3 times
at most to cool down the clothes and
complete discharging process.
Adding more laundry
•
This is only possible under the
following conditions:
– during time delay,
C You may add or remove laundry during
the time delay (until the Programme
starts). At the beginning of a washing
cycle (machine allows adding more
laundry during a future step only if the
water level is low enough to open the
loading door or if the temperature in
the machine is low).
In order to add laundry after the start-
up of the Programme:
1. Press “Start/Pause/Cancel” button.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press “Start/Pause/Cancel” button.
Programme is in rinse hold mode
C This process is shown with the
flashing spin symbol and the standby
symbol which is lit up.
If you wish to spin when the machine is in
this mode:
1. Adjust the spin speed.
2. Press “Start/Pause/Cancel” button.
The Programme continues, pumps out
the water and spins.
3. The standby symbol fades out and the
start symbol lights up.
If you want to discharge the water without
spinning:
1. Press “Start/Pause/Cancel” button.
2. The standby symbol fades out and the
start symbol lights up.
3. The Programme continues and only
pumps out the water.
Re-spinning the laundry
The control system for an unbalanced load
can pause the spinning in cases when the
distribution of the laundry in the drum is
not balanced.
If you want to re-spin the clothes:
1. Distribute the laundry in your machine
for a balanced load.
2. Select the spin Programme.
3. Adjust the spin speed.
After the Programme is finished
Programme indicator symbols on the
screen will remain lit after the Programme
is finished. “End” will appear on the
screen.
1. Open the loading door and take out
the laundry when the door locked
symbol on the display fades out.
2. Press the “On/Off” button.
3. Turn the water tap off.
4. Remove any folds in the rubber seal
on the loading door and check for
debris.
5. Leave the loading door and detergent
drawer open to dry.
6 Quick instructions for daily use