Dascom T2250 Quick Start Guide - Manual (Page 2)

This device fulfils the European standards requirements by complying with the Directive
of the Commission dated May 3, 1989 (89/336/EEC) relating to electromagnetic
compatibility and the Directive dated February 19, 1973 (73/23/EEC) relating to low-
voltage electrical equipment. Conformity with the above mentioned Directives is
indicated by the CE symbol attached to the device.
Note: Conformity may be affected by:
` using interface cables not complying with the specifications
` non-observance of important instructions in the operator's manual
` installing components not approved for this device by the manufacturer
` unauthorized manipulation
FCC Compliance Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio ferquency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a partial
installation. If this equipment does cause interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
` Reorient or replace the receiving antenna
` Increase the separation between the equipment and
receiver.
` Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
` Consult your dealer or an experienced radio/TV technican
for help.
WARNING: To comply with FCC regulations on
electromagnetic interference for a class B computing device,
the printer cable must be shielded. To assure compliance with
FCC regulations for a computing device, use a shielded
interface cable with a metal shell connector. The use of cables
not properly shielded may result in violating FCC regulations.
This digital apparatus does not exceed the class B limits for
radio noise emissions from digital apparatus as set out in the
radio interference regulations of the Canadian department of
communications.
This unit complies with DOC standard C108.8-M 1983
ATTENTION: Le présent appareil numérique n'ement pas de
bruits radioélectriques déspassant les limites applicables aux
appareils numériques de la classe B prescrites dans le
règlement sur le brouillage radio-électrique édicté par le
minstère des communications du Canada.
The paper used is made of raw materials treated with a
chlorine-free bleaching process.
WARNING For continued protection against risk of fire, replace only with same type and rating of fuse. Only trained and qualified personnel may open covers or
remove parts that are not explicitly shown and described in the User Guide as being accessible to the operator.