Briggs & Stratton 40204 - Manual (Page 12)

FEATURES AND CONTROLS
12
SYSTEM CONNECTIONS
Compare this illustration with your generator to familiarize yourself with the location of these important connections:
+12 Volt DC, .5 Amp Output
240 Volt Utility
Wiring for the 2 Pole Connector:
240 Volt Utility — Use to hook up the 240V utility leads from
the transfer switch to the generator.
Wiring for the 10 Pole Connector:
Fault Contacts — Use NO, COM and NC to hook up a siren,
light, etc. to alert you in case of a fault. Contacts reverse
state upon a fault condition.
Remote LED Output — Use this to hook up the remote LED
supplied with the generator. The remote LED will turn on and
off in a series of blinks if certain faults are detected in the
generator.
Transfer Switch Communication — Use TxRx and TxRx GND
to transfer switch and optional wireless StatStation™ to
monitor generator functions.
+12 Volt DC, .5 Amp Output — Internal power supply.
Remote LED Output
Transfer Switch
Communication
Fault Contacts
10 Pole Connector
2 Pole Connector