Dakota Ultrasonics PX-7 User Manual

Page 22

Dakota Ultrasonics

Alarm Mode

The Alarm Mode feature of the PX-7 allows the user to set an audible

and visual Hi / Lo parameter when taking measurements. If the

measurement falls below or above the Hi / Lo limits, set by the user, a red

light will be illuminated on the front panel of the gauge and the beeper

sounded. This improves the speed and efficiency of the inspection process

by eliminating constant viewing of the actual reading displayed. The

following pages outline how to enable and set up this feature:

Using the Beeper

1) While the unit is off, press and hold down the ALRM key.

2) Press ON/OFF key to power up the unit.

3) Release the ALRM key - BEEP ON or BEEP OFF will be displayed

enabling or disabling the beeper.

4) Repeat steps 1 through 3 to toggle between BEEP ON or BEEP

OFF.