How to operate, Warning, Step 1. open bolt – Daisy PowerLine TargetPro 953 User Manual
Page 3: Step 2. put “on” trigger safety, Step 3. pump (once), Caution

HOW TO OPERATE:
WARNING:
Be sure gun is always pointed in a safe direction. Never point the gun
at anyone. Always assume and handle the gun as if it were loaded and ready to fire.
Step 1. OPEN BOLT
Pull the bolt handle fully to the rear. Then, release your hold on the bolt handle, leaving the bolt
open. The gun cannot fire with the bolt open. (See Drawing 2)
Step 2. PUT “ON” TRIGGER SAFETY
The bolt must FIRST be opened, then the trigger safety is pushed from the left to right so that
NO red is showing (See Drawing No. 3). It is a good practice to get into the habit of always keeping
the trigger safety “ON” until actually ready to fire the gun.
Step 3. PUMP (ONCE)
IMPORTANT: Do not pump over one time. This gun
is designed to produce a maximum velocity using a
single pump stroke. Additional pump strokes may
result in serious damage to the gun. The bolt must be
opened to pump gun. For greater safety, we recommend
that the bolt remain open while pumping and that you
close the bolt only when the barrel can be pointed in a
safe direction.
Grasp the pump handle. Pull out and forward as far as
possible. You should hear a fresh charge of air being
drawn into the pump cylinder. Then, return the pump lever
to the original, closed position. (See Drawing No. 4)
CAUTION:
Be sure to grasp pump handle firmly as you close the lever to prevent it from
snapping back and causing possible injury. Also be careful to keep fingers out of cocking
mechanism when closing lever. (See “PINCH POINTS,” Drawing No. 4).
3
Step 1. OPEN BOLT
Step 2. PUT “ON” TRIGGER SAFETY
Step 3. PUMP ONCE
Step 4. LOAD
Step 5. CLOSE BOLT
Step 6. AIM AT SAFE TARGET
Step 7. TAKE “OFF” TRIGGER SAFETY
Step 8. FIRE
BOLT HANDLE
FEED
TRACK
TRIGGER
SAFETY
NO. 3
TRIGGER
SAFETY ON
TRIGGER
SAFETY OFF
red showing on
opposite side
PULL LEVER
OUTWARD FOR
FULL STROKE
THEN RETURN
PINCH
POINTS
NO. 4
DOVETAIL GROOVES
NO. 2