2 install with pc dvr series – Comelit MT 40705 User Manual
Page 25

4. After setting Unit ID, Camera, and RS232/RS485, installing dome camera is basically completed.
Please refer to the manual of DVR for the other installation.
Press the related number of the controller which is correspondent to unit ID of DVR. Then press
DVR button and adjust unit ID of the controller
Make sure if any change is appeared on screen when you press
button of the controller for
basic testing. If there’s no change appeared, verify cable connection and setting of installation.
5.
6.
5.2 Install with PC DVR Series
If user wants to connect with PC DVR, please proceed as the following order.
PTZ Control from DVR
Figure 11 – PC DVR Connection Diagram
1. Connect RS-232C cable between RS-232C Port of PC DVR and RS-232C port of the Keyboard.
(This connection enables PC DVR control remotely from KBD controller)
Plug the RS-232C TO RS-485 converter in the RS-232C Port of PC DVR. Connect wires between
the TX(+/-) of converter and DOME2(+/-) of Keyboard. (This connection enables PC DVR PTZ
control from KBD controller)
How to setup the KBD controller.
2.
3.
A.
B.
C.
D.
Switch the KBD controller ON
Input password (Factory Setting is
)
Open the menu of the KBD controller by pressing
Set as below in Network menu.
Key.
DOME1
RS-232
:
Dome
:
PC-DVR
19
Com Ports
DOME2
:
AUX IN
Set Baud Rate
DOME1
:
9600
DOME2
:
9600
RS232
:
9600
CTRL + MENU
9
9
9
9