beautypg.com

When connected to a switchboard – BT Diverse 2010 User Manual

Page 36

background image

33

BT accepts no responsibility for

damage caused to your Diverse 2010

handset by the use of non-approved

batteries.

No display appears

Is the handset switched on? The
battery may be flat or dead. Recharge or
replace the battery.

No dial tone

Is the telephone line cord plugged into
the phone socket and the base station?

If other handsets are registered on the
base, the outside line may already be in
use. Wait until the call is finished and
try again.

The

symbol is flashing or you

cannot link up with the base station

Is the handset registered with the base
station? To register the handset, see
page 26. Is the power cable connected at
the base and the power switched on at
the wall socket?

If you press the

PHONE

button whilst

is flashing, you will hear four short

beeps from the handset.

If you are still experiencing difficulty,
please call the Diverse Helpline on
0345 908070

.

Please note:
If you go out of range of a base station for
a long time while your handset is switched
ON, it may take more than 20 minutes to
‘find’ the base station again when you
come back within range. However, by
simply switching the handset OFF for a
moment, and then ON again, it will find
the base station within a few seconds.

Recommended batteries should have a
power rating of 600m Ah 1.2V. Batteries
are available from the Diverse Helpline

0345 908070

and your local BT shop.

The base station or handset does

not ring

The ringer volume may be set too low,
or switched off at the base station. To
adjust the ringer volume at the handset
or base station, see pages 17 or 18
respectively.
Is the telephone line cord connected
correctly? See page 6.

Can’t get through, even though a

dialling tone can be heard

You may be set to the wrong signalling
method. To change between TONE and
PULSE dialling, see ‘Additional
features
’, page 15.

When connected to a
switchboard

You can’t get a connection or you get

the wrong connection after speed

dialling

Have you entered a pause after the
access code? See page 24.

Check you have selected the correct
dialling mode. See page 15.

Handset beeps

Are the handset batteries low? You will
hear a beep every 30 seconds.

If is

flashing?

You will hear four short beeps when you
press the

PHONE

button. Check you are

still in range of your base station.

Buzzing noise on my

Radio/TV/Answering Machine/PC

Diverse is too close and is causing
interference. Move it further away.