Cambridge SoundWorks T100 Tower Loudspeakers - Manual (Page 8)

6
MAKING THE CONNECTION
1. Unscrew the speaker’s red and black connector
knobs to expose the holes in their threaded shafts.
2. Insert the stripped end of one cable’s “indicated”
conductor into the speaker’s red (+) connector.
Hand-tighten the knob to secure the connection.
Make sure no stray strands of wire are exposed.
If you are using a cable connector plug, connect it
according to its instructions
3. Repeat the procedure for the cable’s other conduc-
tor and the speaker’s black (–) connector.
4. Connect the other speaker cable’s conductors to the
other speaker.
5. Connect the opposite ends of the speaker cable to
the speaker outputs of your receiver. Remember to
observe channel and polarity (Left Positive, Left
Negative, Right Positive, Right Negative).