BLACKHAWK! AXIOM U/L RIFLE STOCK CAMO FINISH - Manual (Page 5)

www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
Sling Mounting Tips
Page 8
1. Slit for 1.5” multi-point sling.
2. Pre-Install sling stud for installation of sling swivel and sling.
3. Alternate locations for sling stud mounting. Remove stud from factory installed
location and relocate to desired position on left or right side of stock.
Forend Sling Stud Location:
The forend is designed with two additional optional sling stud locations. (Fig. B)
Install additional sling stud or relocate pre-installed sling stud.
1. Optional pre-formed sling stud locations. (Fig. B)
2. Pre-installed sling stud location. (Fig. B)
Note: To utilize optional pre-formed sling stud locations, drill 13/32 hole through preformed
mounting locations (#1 Fig B).
Note: To prevent damaging the composite forend take precaution to not overtighten sling
stud or bi-pod accessories.
Fig. A
Fig. B
1
2
3
www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
Page 9
NOTE: Alignment with scopes or raised sights can be improved by purchasing cheek rest accessory
part# K99900-C. Please contact BLACKHAWK! for ordering information.
INSTALLATION STEPS:
1. Determine the correct height cheek rest. Note: The cheek rest is packaged as two separate pieces: Part 1,
"Lower" cheek rest used for raised rifle sights or low mounted scopes; Part 2, "High" cheek rest used for raised
scopes (Most commonly used).
IMPORTANT NOTICE: Once installed the Cheek Rest is difficult to remove. Please plan your desired Cheek Rest
configuration carefully.
2. If the desired configuration involves the use of the high cheek piece proceed with this step. If the desired con-
figuration involves only the use of the low cheek piece proceed to Step 3. Utilizing the high cheek piece requires
the use of the low cheek piece. With the two long flat edges facing down, place the low cheek piece on a level
work surface. Take the high cheek piece in one hand while holding the low cheek piece in a steady position.
Slide the high cheek piece down over the top of the low cheek piece. (Fig. 1) Note: Imprinted "Power Pak" logo
on the high cheek piece should align with the logo on the low cheek piece. The high cheek piece should lock
down and completely cover the low cheek piece. The rear portion of the high cheek piece should be flush with
the rear portion of the low cheek piece.
3. To complete Cheek Rest installation, remove the rear portion of the Axiom Rifle Stock. With the butt pad fac-
ing down, place the rear portion of the stock on a flat work surface. Take the assembled Cheek Rest with the
rear of the Cheek Rest assembly facing down and slide down over the rear portion of the stock. With both
hands, push FIRMLY down until rear of Cheek Rest assembly is aligned with the front of the rubber butt pad. (Fig.
2) Note: The angled “gripping teeth” on the inside of the Low Cheek Piece should be positioned with angle fac-
ing the work surface.
4. Reinstall the rear portion of stock back onto Axiom Rifle Stock (Fig. 3)
Fig. 1
Fig. 2
Fig. 3
Cheek Rest Accessory Installation
(PART# K99900-C)