BLACKHAWK! AXIOM U/L RIFLE STOCK CAMO FINISH User Manual
Axiom rifle stock, Owner’s manual, Installation instructions
www.BLACKHAWK.com
BLACKHAWK!
®
NORFOLK, VA U.S.A. 1.800.694.5263
50107098 REV. 04.09
AXIOM Rifle Stock
Owner’s Manual
™
Page 1
www.BLACKHAWK.com
BLACKHAWK!
®
NORFOLK, VA U.S.A. 1.800.694.5263
Installation Instructions
ATTENTION: Read and follow all instructions and warnings prior to installation and/or fir-
ing a Axiom equipped firearm. Take extra time to review the shooting tips & techniques
section of this manual (Page 7). If you are at all unsure of your ability to install your Axiom
Rifle Stock safely, please seek the services of a competent gunsmith.
WARNING 1: Before beginning stock installation, make sure that the rifle is UN-
LOADED. Carefully check the chamber and magazine making both visual and touch ver-
ification.
WARNING 2: The Axiom Rifle Stock is not compatible with oversized trigger guards.
Use of the Axiom Rifle Stock with an oversized trigger guard will cause product failure and
possible injury. Note: Most factory installed trigger guards are compatible with the Axiom
Rifle Stock.
WARNING 3: The Axiom Rifle Stock is not compatible with trigger guard mounted
oversized safeties. Use of the Axiom Rifle Stock with an oversized safety will cause prod-
uct failure and possible injury.
TOOLS REQUIRED:
• Large Flat Blade Screw Driver
• Hex Key / Allen Wrench Set
• Torque Wrench (Recommended)
• Extended “ball end” Allen Wrench (Included)
INSTALLATION STEPS:
1. Remove action bolt from receiver. Remove original stock. Refer to manufacturer’s in-
structions for the best method to remove stock. Normally the barreled action is held in po-
sition by two screws located on the bottom of the stock. Using caution not to damage
screws, use the appropriate size and type of tool to remove the two screws (Fig. 1A).
Note: At this point the trigger guard is disconnected from the stock. For BDL models re-
move bottom magazine floor plate along with magazine housing. (Fig. 1B on the follow-
ing page) Remove barreled action from stock. To avoid damage, take caution when
removing barreled action from original stock.
Fig. 1A