BLACKHAWK! AXIOM U/L RIFLE STOCK CAMO FINISH - Manual (Page 2)

www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
Installation Instructions Continued
Page 2
2. Prepare Axiom Rifle Stock for Installation by removing rear butt stock. To remove pull down on
lever assembly and slide off buttstock. (Fig. 2)
3. Installation of the Axiom Rifle Stock also requires the removal of the pistol grip portion of the
stock. The stock is attached to the forend with a preinstalled bolt and lock washer. To loosen bolt,
insert the provided 1/4” ball end allen wrench into the hole located on the bottom of the stock. Turn
wrench counter clockwise until stock is free from forend. (Fig. 3)
Fig. 1B
Fig. 2
Fig. 3
www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
Installation Instructions Continued
Page 3
4. Carefully insert receiver or barreled action into the forend. Carefully align recoil lug
and trigger with corresponding pockets or openings. Slowly lower barreled action into
forend until it is fully seated. (Fig. 4) Note: The barreled action should slide into position
with limited hand pressure and when in final position there should very minimal
movement.
5. While holding the assembly from Step 4, reinstall the magazine housing into the cor-
responding pocket on the bottom of the receiver. (Fig. 5) Note: To avoid damage to the
hinged floor plate and trigger guard in the following steps, the magazine housing must be
correctly installed in the receiver. Verify that the magazine housing is properly installed.
Fig. 4
Fig. 5