Bedrug BED LINERS: BedRug - Manual (Page 4)

BedRug Bedliner Installation Instructions
Procedure
BRINST Rev. Level: 15 12/4/2009 Page 4 of 6
6. Installing BedRug floor and bulkhead
(a) Locate BedRug in the truck bed.
(b) Position the BedRug - front to rear and left to right by
aligning all edges and tucking corners into place. (Fig
6-1)
(c) Roll the Bed Rug floor to you, exposing the 1”x36”
fastener located on the BedRug bottom.
(d) Clean attachment area thoroughly with alcohol and
allow to dry.
(e) Remove the film. (Fig 6-2)
(f) Roll the BedRug floor and sidewalls back in place.
(g) Firmly press the Bed Rug top surface for 15 seconds
to ensure adhesive attachment.
(h) Repeat for other side
(i) Fit top edge of BedRug bulkhead to top edge of body
panel to determine best location. (Fig 6-3)
Be sure fasteners are located on a flat solid surface of
truck bed.
(j) Clean attachment areas thoroughly with alcohol and
allow to dry.
(k) Remove the film working from bottom to top and
center of part outboard.
(l) Roll the BedRug top edge back in place.
(m) Firmly press the Bed Rug top surface for 15 seconds
to ensure adhesive attachment.
7. Fitting BedRug for beds with tie-down hooks
or other optional features
Some truck beds are equipped with tie-down hooks,
load extenders and other functional equipment
located in the floor, bulkhead or sidewalls. For
these the installer must either:
(a) Cut a small slit in the appropriate area allowing the
equipment to protrude through the BedRug surface
(This will not damage the BedRug) or,
Fig. 6-2
Fig. 6-1
Fig. 6-3