Barranca Diamond HP14 Slab Saw - Manual (Page 9)

9
HP14 SPECIFICATIONS
Motor Baldor
Horsepower 1/2 Hp
Voltage 110V / 60 Hz
Amperage 9.6 Amps 110 volts, 4.8 Amps 220 volts
Motor RPM 1725 RPM Fixed
Motor Arbor Diameter ¾ inch
Duty Continuous
Blade Capacity 12 or 14 inch diameter
Power Feed Motor Dayton Shaded Pole AC Gear motor
Horsepower 1/50 HP
Motor Voltage 110V/60Hz
Motor RPM 6 RPM (full load) Fixed
Torque 150 inch-lbs.
Rotation Clockwise facing the shaft
Motor Arbor Diameter 5/16 inch
Part Number 8302014
MOTOR
Motor arbor bearings are sleeve-bushing type and permanently sealed.
FEED MECHANISM
Power Feed Threaded Rod 23.5" long x 3/8-24 fine LH (left hand) threaded rod stainless steel
Power Feed Clutch Block: 2 piece: lower silicon bronze block half-threaded 3/8-24 fine thread with mounting
clearance hole and upper brass friction block (unthreaded).
Maximum rock material vise capacity: 6 inches
Cross Feed Index Movement per Revolution of Handle: 1/16 inch
Power Feed In-Feed Vice Advancement Rate: approximately 3/16 inch per minute
LUBRICATING SYSTEM
Saw lubricant (petroleum or synthetic lubricant) requires that the reservoir tank be filled with 2.2 gallons filled to
cover the 1/4" to 3/8" of the diamond blade kerf (outside cutting edge).
CONTENTS
Barranca Diamond HP14 Slab Saw (part # 8302014).
301 Supreme notched rim blade 14" x 0.060 x 1 (part # 166070 or 303C Professional continuous rim blade 14" x
0.070 x 1 (part # 156727).
UNPACKING AND ASSEMBLY
Your HP14 Slab Saw has been shipped from the factory thoroughly inspected, tested and ready for use after the
saw has been prepared.
PRE-START INSPECTION & SET UP
After removing your HP14 Slab Saw from the shipping crate, place the saw on a flat surface such as a secure
bench top or table, or optional stand (part # 166153).