Bakers Pride FC-816 Manual - Manual (Page 5)

2 1/4
(57mm)
30" STD.
(762mm)
FRONT VIEW
12"
(305mm)
33"
(838mm)
10”
(254mm)
3. SET-UP: The oven must be installed in a well-ventilated area.
Your oven is packed standing on its back. Leave in on it's back while unpacking. The skid may be left under
the oven for convenience in further handling. Unpack carefully to avoid damage to the oven. If concealed
damage is found, follow the instructions detailed in Section 1.
Keep the area around the oven free and clear of combustible materials. Do not store any materials on top
of or under any oven. Provisions for adequate air supply to your oven for ventilation and proper gas
combustion is essential. As a minimum, observe the clearances detailed in Section 2.
Provide adequate ventilation and make up air in accordance with local codes.
The oven must be installed under a ventilation hood. Fit the flue diverter (see Sketch “C”) into the hole in
the top front of the oven and secure with the screws supplied. Local inspectors and ventilation specialists
should be consulted to make sure that the installation of the hood conforms to the local codes and
requirements (see Sketch “D”).
In the U.K., ventilation requirements detailed in BS 5440 should be followed.
Access to the bottom front door and left side control panel is required for day to day operation of the oven
and for servicing. Make sure that these areas are kept unobstructed for easy access.
Sketch “B”
#
BAKE RS PR IDE
Main Burner
Oven Controls
Push-Pull Knobs