Autoquip TITAN UPENDER - Manual (Page 3)

3
IDENTIFICATION
When ordering parts or requesting information or service on this unit, PLEASE REFER
TO THE MODEL AND SERIAL NUMBER. This information is on a nameplate attached
to the assembly. Replacement parts are available from a local Autoquip distributor.
INSPECTION
Immediately upon receipt of the unit, a visual inspection should be made to determine
that it has not been damaged in transit. Any damage found must be noted on the
delivery receipt. In addition to this preliminary inspection, the unit should be carefully
inspected for concealed damage. Any concealed damage found that was not noted on
the delivery receipt should be reported in writing to the delivering carrier within 48 hours.
The following is a checklist that will aid in the inspection of the Upender.
1. Examine the entire unit for any signs of mishandling. Pay special attention to the
power unit and pushbuttons.
2. Thoroughly examine all connections, making sure they have not vibrated loose
during transit.
3. After installation, raise the Upender and inspect the base frame, platform, tilt
linkages, and cylinder plumbing connections.
IDENTIFICATION & INSPECTION