Autoquip PDQ DOCK LIFT - Manual (Page 11)

11
*Model Low.
Ht.
(In.)
Lift
Cap
(lbs)
Axle Load
Capacity
Over
Bridge
End
(lbs)
Axle Load
Capacity
Opposite
Bridge
End
(lbs)
Platform
Size
(In)
Base
Frame
Size
(In)
Max
Travel
(In.)
Ship
Wt.
PDQ-40 4 1/2 4,000 2,000 2,000 60 x 80 76 x 84 55 1/2 2,700
PDQ-50 4 1/2 5,000 3,000 3,000 60 x 80 76 x 84 55 1/2 2,800
PDQ-60 4 1/2 6,000 3,000 3,000 60 x 80 76 x 84 55 1/2 2,900
NOTE: All PDQ Models have a standard 5 HP motor (230/60/3) with a nominal standard
speed of 15 fpm, and have two rams.
All PDQ Scissors Lifts have a rollover capacity equal to twice the lifting capacity when in
the fully lowered position.
The PDQ can handle pallets, carats, electric walkie and hand trucks. Although the PDQ
is designed to unload freight, it can also be used for loading. Using a PDQ, one person
can load or unload a full trailer safely in 25 to 30 minutes, using a pallet jack.
LOAD CAPACITY
The load capacity rating is stamped on a metal plate attached to the lift. This figure is a
net capacity rating for a lift furnished with the standard platform. The relief valve of the
pumping unit has been set to raise the weight, plus a small amount for overload. Where
gravity roll-sections, special tops, etc, are installed on the lift after leaving the plant,
deduct the weight of these from the load rating to obtain the net capacity. Lifts should
not be overloaded beyond the established capacity as damage and/or personal
injury may result.
SPECIFICATIONS